![](https://somethingnew.ca/wp-content/uploads/2024/04/image-31.png)
I added a cavity to accept a 10mm x 2mm magnet. Once the printer started printing the layer which will cover the magnets, I paused it. I placed the magnets in the cavities then pressed continue.
![](https://somethingnew.ca/wp-content/uploads/2024/04/image-32.png)
This print was a bit over 2 hours.
![](https://somethingnew.ca/wp-content/uploads/2024/04/image-33.png)
I’m honestly not sure how much these magnets will help.
![](https://somethingnew.ca/wp-content/uploads/2024/04/image-34.png)
If nothing else, I just made a weird fridge magnet. 🙂
Leave a Reply
You must be logged in to post a comment.