Even when I think I’m finished, I’m really not. The lid didn’t fit properly. Well, it was fine except the switch location didn’t fit. (the switch interfered with the motor mount) And, I realized that extruding the “doorstop” at 90 degrees to the plane was wrong. That back point is NOT 90 degrees. It’s a bit more than 100. So, after moving the switch slightly and re-extruding the doorstop to be parallel to the lid, the holes no longer lined up with that print.
I fixed those, printed a new lid, and I think we finally have it.
Leave a Reply
You must be logged in to post a comment.